Viva Megasmotard
,Antes demais aconselho-te a fazeres a tua apresentação á comunidade no local indicado para o efeito http://www.bmwcklt.com/forums/forumdisplay.php?f=2
Respondendo á tua pergunta:
- é ABS I ou II
- pelo que tu dizes, terás á partida que fazer um reset á unidade
Tenta seguir as seguintes instruções (espero que saibas inglês
):Resetting ABS1
Locate the diagnostic connector on the right frame rail, under the seat. Remove it from the blanking plug.
Insert one end of 20 cm wire into the middle socket of this connector.
Ground the other end firmly to a metal bolt in the area (and keep grounded).
Hold the ABS button down as you turn the ignition on. You should see the lights flash together as normal.
Keep holding the ABS button down for about 8 seconds. The ABS light will stay on solid.
Release the ABS button.
Turn off ignition, remove wire.
Resetting ABS2
Locate the diagnostic connector under the seat. Remove it from the blanking plug.
Insert one end of 20 cm wire into the middle socket of this connector.
Ground the other end firmly to a metal bolt in the area (and keep grounded).
Turn on ignition. You should see the lights flash alternately.
Hold ABS button down for about 8 seconds. The bottom ABS light will stay on, and the top one off.
Release the ABS button. If you have successfully reset the ABS, both ABS lights will come on. If you have failed to count to 8, or your ground is not good, the top ABS light will stay off.
Turn off ignition, remove wire.
Se tiveres alguma dúvida diz.
Cmpts
:wacko::lol::lol::lol:
